Identifying the Name of the Scanner Device Driver
You must identify the name of the SCSI device that is working with your scanner so that you can configure Harmony to communicate with it.
Device drivers all have names starting with /dev/sg. If your scanner is the only generic SCSI device connected to your system, it is likely that the name of its driver is
If you are uncertain about the device name, you can use the findscanner utility provided with Harmony. Use the findscanner utility to probe your SCSI bus for devices. It will tell you the name of the device being used by scanners attached to your system.
|‣||Start the findscanner utility. While in the bin folder of your Harmony installation, type the following in a terminal or command prompt:|
The findscanner utility is installed in /usr/localToonBoomAnimation/harmony_14/ln86_64/bin/
If there are scanners connected to your computer and they are properly installed, the findscanner utility will return information like the following:
/dev/sga type=6: Scanner device RICOH IS450 Vers:1R04
/dev/sgb type=6: Scanner device FUJITSU fi-4750Cdm Vers:0G00
If findscanner cannot find SCSI scanners attached to your computer, it will return a statement like this:
No scsi devices attached
If you get this message, it may indicate that your system could not initialize your SCSI adapter at boot time.
- Go to the /boot directory and rename the initrd-[version].img file, where [version] represents the version of your kernel. You can run the uname -r command to find out the version of your kernel.
mv initrd-2.4.18-3.img noscsi-initrd-2.4.18-3.img
- Type the following command:
/sbin/mkinitrd initrd-2.4.18-3.img 2.4.18-3
This command recreates a new "init ramdisk" image that will load your SCSI driver when your system starts.
- Reboot your system.